TY - JOUR AU - BENSAADA, S. AU - FELIACHI, D. TI - EFFET DU TAUX DE DEFORMATION SUR LES PROPRIETES MECANIQUES ET STRUCTURALES LORS DU RECUIT DE RECRISTALLISATION DE L’ALLIAGE Cu-4,6At.%In THE EFFECT OF THE DEFORMATION RATE ON THE MECHANICS AND STRUCTURAL PROPERTIES DURING RECRYSTALLIZATION OF ALLOY Cu-4,6 JF - Courrier du Savoir; Vol. 5 (2004): Courrier du Savoir KW - N2 - Ce travail à pour but de mettre en évidence l’effet du taux de déformation sur l’évolution des propriétés mécaniques et structurales de l’alliage Cu-4,6 at-.%In, homogénéisé et trempé ensuite déformé par laminage à froid et recuit à une température de 550°c. La microscopie optique et la microdureté Vickers sont les principales techniques d’analyse utilisées pour le suivi de l’évolution structurale et celle des propriétés mécaniques au cours des différents stades du recuit. Les résultats obtenus confirment d’une part l’influence notable du taux de déformation sur la taille des grains recristallisés et d’autre part conditionnent la formation de nouveaux grains par un taux critique de déformation avoisinant 10%.     The aim of this paper is to clarify the effect of the deformation rate on the evolution of the mechanic and structural properties of alloy Cu-4,6 at.%In homogenized, quensched, then deformed by cold lamination and cooked at a temperature of 550°C. The optical microscopy and microhardness Vickers are the stricking methods of analyis used for the follow ap of the structural evolution and those of mechanic properties during the different stages of cooking. The obtained results confirm from on side the notable influence of the deformation rate on the size of the recrystallised grains and from another side it will condition make ready the formation of grains again by a critical rate of deformation around 10%. UR - https://revues.univ-biskra.dz/index.php/cds/article/view/309